Altair WBS-200 Especificaciones descargar pdf (Pagina 15)

WB-200 SERIES INTERCOM SYSTEM — WBS-200 DUAL CHANNEL WIRELESS BASE STATION

the maximum cancellation of your own voice (that is to say that you won't hear your voice

through the headphones), totally to the right or to the left giving the maximum level of voice,

passing through all the intermediates level positions.

PROGRAM INPUT ON SWITCH

The program input on switch allows to enable/disable the send of the program

input signal to the intercom channel selected with the radio to A/B switch placed at the

rear panel (the signal introduced by the program input connector XLR-3-31 placed at the

rear panel).

If the program input is enabled, its associated LED will light up, and on the other hand,

if it is disabled, its associated LED will turn off.

PROGRAM INPUT LEVEL CONTROL

The program input level control adjusts the signal level sent to the intercom

channel selected with the radio to A/B switch placed at the rear panel (the

signal introduced by the program input connector XLR-3-31 placed at

the rear panel). Next to the program input level control is marked the

position in which the gain is 0, that is to say the same signal as in the

input. Totally to the left the signal decreases in 10 dB and totally to the right the

signal increases in 20 dB.

Keep in mind that these gains are influenced by the position of the program input

MICRO/LINE switch selector (placed at the rear panel), becouse if this switch is in mode

micro, we have 30 dB of additional gain.

RADIO REGISTER SWITCH

This switch is provided to register and deregister the wireless beltpacks of the

wireless intercom system. Each beltpack can be registered in two different base stations,

so that if it loses the range of one, changes the operation to the other base station. Each

base station can register a maximum of four beltpacks.

To register a beltpack to the base station, turn on the base station, and press and hold the

buzzer it is turned on) and will blink the associated REGISTER led and the IN-RANGE (1-4)

leds corresponding where is going away to register the new beltpack.

If we do not do anything during 60 seconds the function will be reset.

If we pressed key REGISTER again the function will be reset.

With the beltpack that we want to register turned off, turn on pressing the ON/OFF switch

maintaining pressed the VOLUME UP/DOWN (to register it in base 1) switches or maintaining

pressed the VOLUME UP/DOWN and the BUZZER ON/OFF (to register it in base 2) switches.

If everything goes well, the base station base will sound (if the buzzer it is turned on) and the

beltpack also (if the buzzer it is turned on), the correnpoding base station IN RANGE led will turn on

and the beltpack IN RANGE led begin to blink.

If the procedure fails, turn off the base station and the beltpack and to return to begin.

To deregister all the beltpacks registered in the base station, turn on the base station with the

station turned off. At this moment, turn off the base station and all the beltpacks will be

deregistered.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Sin comentarios

Altair WBS-200 Especificaciones Pagina 15