14
WB-200 SERIES INTERCOM SYSTEM — WBS-200 DUAL CHANNEL WIRELESS BASE STATION
The remote mute ALL MICS switch carries out the function upon pressing it. This means that
the units (wired and wireless beltpacks, desk stations units, etc.) connected to the system can turn
on the microphones again when it’s required. When this switch is pressed, its associated LED turns
on during a moment.
The BUZZERS switch, on the other hand, carries out an on/off function. If the remote mute
buzzers function was enabled, when the remote mute buzzers switch is pressed the remote mute
buzzers function is disabled and the associated LED becomes turned off (in this moment all the
external units could enable their local buzzers again); if, on the other hand, it was disabled, when
the remote mute buzzers switch is pressed the remote mute buzzers function is enabled and the
associated LED becomes turned on (at this moment the buzzers of all the external units will be
disabled and they can not be enabled again locally).
The BUZZER ON/OFF of the base station is carried out with the BUZZER REMOTE MUTE,
enabling/disabling the buzzer sound when the unit receives a call or when the user press a key.
CALL SWITCH
The WBS-200 base station is provided with one call switch. When this switch is
pressed a call signal is sent to the intercom selected with the radio to A/B
switch placed at the rear panel. The call signal makes the LED associated
with the switch start blinking; if the buzzer its not remote muted (consult
remote mute all mics and buzzer switches for more information) an intermittent
sound takes place during three seconds, the same as in all the units (wired and
wireless beltpacks, desk stations, master stations, etc.), connected to the intercom channel
selected.
If the CALL switch is pressed continuously, the duration of the call signal will be higher (the
time that the switch is pressed, and approximately 3 seconds more).
If a call signal is generated in an external unit (wired and wireless beltpacks, desk stations,
master stations, etc.), the LED associated to the CALL switch, will start blinking and if the buzzer is
not remote muted (consult remote mute all mics and buzzer switches for more information) an
intermittent sound will take place during about three seconds.
If a call signal is generated in a wireless beltpack of the intercom system, the
corresponding IN RANGE led to the beltpack number start blink.
MIC ON/OFF/PUSH TO TALK SWITCH
The WBP-200 base station unit is provided with a talk switch. The TALK switch
allows to enable/disable the microphone, so that we are able to speak with other units
connected to the same intercom channel selected with the radio to A/B
switch placed at the rear panel.
If the microphone is activated, its associated LED will light up, and on the other
hand, if it is disabled, its associated LED will turn off.
The TALK switches have two operation modes. When this switch is pressed
quickly, the microphone changes its state; if it was enabled, being pressed it gets disabled and
turns off the associated LED, and if it was disabled, being pressed it gets enabled and turns on the
associated LED.
When the TALK switches are pressed and held, the unit will enter in the special function PUSH
TO TALK; this means that the microphone will be enabled until the switch is released.
SIDETONE CONTROL
The sidetone control adjusts the level of your own voice as you hear it in your
headphones. It is designed to make approximately at the potentiometer halfway travelling
(30 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales