Altair Glide Computer and Navigation System El manual del propietario descargar pdf (Pagina 33)

D ELECTRICAL CONNECTORS

2: Supply ground

3: Switched 12V out to supply external devices (such as Vega or

FLARM)

4: Supply ground (used as external supply return)

5: OneWire peripheral bus signal

6: Supply ground (used as OneWire bus ground)

Note: Use the operating tool supplied to open the spring clamp.

D.2.2 Connector X3

Type: WAGO 733 Cage Clamp terminal

1: Ground

2: Reserved, do not connect any signals!

3: Reserved, do not connect any signals!

4: Reserved, do not connect any signals!

5: Reserved, do not connect any signals!

6: Reserved, do not connect any signals!

Note: Use the operating tool supplied to open the spring clamp.

D.2.3 Connector X4: Primary data port

Connector numbered not according to IGC speciﬁcations (RX/TX crossover).

Connect your intelligent variometer to this port.

Typ: RJ45, IGC Layout RX/TX Crossover

1,2: GND, external device GND

3: RS232 TX, Data sent from Altair

4: RS232 RX, Data received by Altair

5,6: Not connected

7,8: 12V, External device supply, DO NOT feed in power to this Pin!

Note: TX/RX crossed. Non IGC standard!

Altair Owner’s Manual • ALTAIR-EN 26

1 2 ... 28 29 30 31 32 33 34 35 36 37 38

Sin comentarios

Altair Glide Computer and Navigation System El manual del propietario Pagina 33