7
WBP-200 SINGLE CHANNEL WIRELESS BELTPACK.
To turn off the beltpack, press and hold two seconds the ON/OFF switch when the beltpack is
turned on. In this moment will sound the buzzer (if the buzzer is turn on) and when the ON/OFF switch
it is depressed, the beltpack it is turned off.
If the ON/OFF switch it is short pressed, the beltpack will show us the battery status (LOW BAT led
— 10%, BUZZ ON/OFF led — 40%, MIC ON/OFF led — 70% and IN RANGE led — 100%).
IN RANGE LED
The IN RANGE led when blinks indicates that the beltpack is in the station base
range, if it is turn on without blinking, indicates that the beltpack is not in the station
base range.
VIBRATOR ON/OFF
When we press at the same time the MIC ON/OFF switch and the
BUZZ ON/OFF switch we turn on/off the vibrator. If the vibrator it is in on
mode, the vibrator turn to off mode and if the vibrator it is in off mode, the
vibrator turn to on mode.
If the vibrator it is turned on, when a call is received, the unit vibrates.
The state of the VIBRATOR (on/off), it is stored in the unit.
STANDBY MODE
When the beltpack is turn on and we press the ON/OFF switch and the
VOLUME DOWN switch at the same time, the beltpack
change to STANDBY mode. In this mode, the beltpack can
receive CALLs, but the audio it is disconnected. This mode is useful to save
battery, since the beltpack less consumes 5 times than in full duplex state.
To exit from STANDBY mode, press shorted the ON/OFF switch.
MIC GAIN ADJUSTMENT
The mic gain adjustment allows attenuating or amplifying the mic signal. When press
the MIC ON/OFF switch and at the same time the UP or DOWN VOLUME
switch, the mic gain it is adjusted, the four leds of the beltpack
turn to indicate the mic gain. There are 15 steps of mic gain,
the LOW BATTERY led indicates the first step, the BUZZ ON/OFF led indicates the
sixth step, the MIC ON/OFF led indicates the eleventh step and the IN RANGE led
the fifteenth step of the mic gain.
The MIC GAIN, it is stored in the unit.
SIDETONE GAIN ADJUSTMENT
The sidetone gain adjustment allows attenuating or amplifying the own mic signal that
we listen in our headphones. When press the BUZZER ON/OFF switch and
at the same time the UP or DOWN VOLUME switch, the sidetone
gain it is adjusted, the four leds of the beltpack turn to indicate
the sidetone gain. There are 10 steps of volume, the LOW BATTERY led indicates
the first step, the BUZZ ON/OFF led indicates the fourth step, the MIC ON/OFF led
indicates the seventh step and the IN RANGE led the tenth step of the mic gain.
The SIDETONE GAIN, it is stored in the unit.
(23 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales